Academy Mechanical Services

Client: Spruce Grove Shop Expansion
Type: 5000 sq ft Sheet metal structure

The customer required interior and exterior wiring on the new structure including:

• T5HO fluorescent High-Bay Light Fixtures
• Receptacles throughout the interior
• Emergency Lights
• Conduit Systems for both power and low-voltage controls
• New 100A Branch Circuit Panelboard

In order to fully satisfy the customers’ needs, we had to respond to the job quickly, as the winter months were setting in and the customer needed power inside the structure to keep it warm. Through hard work and efficient planning, we were successful in providing this to the customer.

Albany Market Square CRU #13

Client: Cameron Developments Ltd.
General Contractor: Kor Alta Construction Ltd.
Completed: September 2014

Construction of a 9,500 sq. ft. base building for Commercial Retail with 8 tenant bays. Project included installation of main incoming service, construction of a main electrical distribution system, installation of tenant feeders and panels, installation of various styles of exterior LED light fixtures, and the wiring of Roof Top HVAC Units.

Leduc Industrial Condos

Client: Private Client
General Contractor: Client acted as their own
Completed: September 2014

Construction of a 22,440 sq. ft. base building for industrial condo use with 6 tenant bays. Project included the installation of main incoming service, construction of a main electrical distribution system, installation of tenant feeders and panels, exterior lighting, as well as the installation of fluorescent high-bay lighting in each bay.

Habit HQ Office Building (Formerly Ignition Media HQ)

Client: Tim Hanas / Ignition Media
General Contractor: Bonn Construction Ltd.
Completed: February 2014

Complete interior renovation of an existing 8,300 sq. ft. 2-storey building with full basement from the 1950’s. Complete demolition of existing electrical system, save for some existing panels mounted in block walls.

• Installed a new 400 amp service to the building to handle all new loads.
• Constructed a new main electrical room.
• Installed new addressable Fire Alarm system throughout
• Installed cable suspended architectural lighting throughout building.
• Installed new LED Exterior light fixtures for security / parking lot lighting.
• Installed and terminated all data & communications cabling (200+ runs of CAT6)
• Installed conduits and cabling for security system, provided provisions for future security expansion.

NAIT Distribution Warehouse Re-feed

General Contractor: EPCOR Distribution and Transmission
Completed: October 2014

Installed a new rigid 4” conduit from ground level into the building and extended to existing 4,160 Volt customer owned primary switch gear. Installed new 15 kV primary cables from new padmount transformer, terminated the high voltage cables in the transformer, and terminated to customer switchgear. The work was done in concert with EPCOR’s conversion of the area to 13,800 Volts in order to still provide the customer 4,160 Volts.

Sentinel Storage re-feed

General Contractor: EPCOR Distrubtion and Transmission
Completed: April 2014

Assisted in the installation of new 15 kV Primary cables and installed a new conduit into existing customer owned 4,160 volt switchgear. Terminated the cabling in the new padmount transformer and terminated inside of the customers switch gear.

Rollies Miles Athletic Field

Client: City of Edmonton
General Contractor: Wilco Contractors Northwest
Completed: August 2013

Installed new underground conduit system for future electrical requirements. System was complete with polymer concrete junction boxes mounted flush with grade for access / pull points.

Victoria Golf Course Club House re-feed

Client: City of Edmonton
General Contractor: EPCOR Distribution and Transmission
Completed: April 2013

Installation of a new underground conduit as well as surface mount conduit and pull boxes mounted to the side of the building to re-feed the club houses’ main service. The work was done in concert with EPCOR as they were eliminating an aerial mounted transformer to install a new padmount transformer on the ground due to safety concerns.

Victoria Golf Course Club House – Main Service Rebuild

Client: City of Edmonton
General Contractor: City of Edmonton
Completed: April 2013

While EPCOR had initiated the re-feed of the of the golf courses club house the City of Edmonton’s Electrical department wanted to update/upgrade their old electrical equipment with new equipment. We were able to re-build the main electrical distribution system, all while minimizing outages and keep their power on with a generator and some temporary connections.

• Installed new 400 amp main service disconnect
• Installed new CT Cabinet with new CT’s
• Installed a new 600 amp central distribution panel.
• Installed a new 150 amp panel to re-feed an older existing panel that was feeding the club house’s mechanical loads.
• Installed a new splitter box and spliced out the feeds to the existing panels in order for
  them to reach the new breakers in the new central distribution panel.

MTRS – Multi-Tournament & Recreation Site

Client: City of Edmonton / Various Rugby and Soccer Clubs General
Contractor: Wilco Contractors Northwest
Completed: Spring 2012

• Installation and termination of street lights throughout the site
• Installation and termination of street light controller panels
• Interior and Exterior wiring of two irrigation pump houses on site
• Installation of three-phase wiring throughout the site for street lighting
• Installed a custom weatherproof main distribution cabinet with a step-down transformer to
  distribute the new 600V service to existing loads that require 120/208V